Aluminium Window Spraying for Multi-Storey Homes and Townhouses Gold Coast | RepaintPro

Aluminium Window Spraying for Multi-Storey Homes and Townhouses Gold Coast

Why Multi-Storey Properties Need Specialist Window Spraying

The Gold Coast is full of two-storey homes, three-level townhouses, and multi-storey complexes built over the past few decades. These properties often have outdated aluminium window frames in cream, silver, or bronze.

While single-storey homes can be straightforward to spray, multi-storey properties require specialist systems:

Access equipment such as scaffolding or elevated work platforms.

Safety compliance under QBCC and insurance guidelines.

Experience with wind, height, and complex masking challenges.


That’s why aluminium window spraying in multi-storey homes is a job for professionals, not DIY.


—

Why Frames on Multi-Storey Properties Date Faster

Higher windows are exposed to harsher elements than ground-level ones:

UV exposure – Sunlight hits upper storeys for longer periods.

Windborne salt – Coastal suburbs like Palm Beach, Currumbin, and Tugun push salt spray further up façades.

Rain run-off – Upper frames cop heavier water flow, leaving streaks and corrosion.


Without professional repainting, these frames fade and degrade quickly, dragging down the look of the entire property.


—

The Process for Multi-Storey Aluminium Window Spraying

RepaintPro follows a strict system designed for safety, durability, and presentation:

1. Site Assessment

Inspect access points, height, and surfaces.

Plan scaffold, ladders, or boom lifts where required.

Ensure compliance with insurance and safety laws.


2. Surface Preparation

Wash down to remove salt, dirt, and chalking.

Sand and key aluminium for adhesion.

Degrease to eliminate contaminants.


3. Masking

Professional tape and sheeting around glass, tiles, and render.

Extra care at heights to prevent tape lift in wind.


4. Priming

Norglass All Surface Primer: 30–40 microns DFT per coat.

Two coats = 60–80 microns of adhesion foundation.


5. Spraying

HVLP system for even topcoat application.

Concept Acrylic Lacquer: 25–35 microns DFT per coat.

Multiple coats ensure a total system build of 40–60 microns.


6. Finishing

Careful tape removal for razor-sharp lines.

Reinstallation of flyscreens and sliding doors.

Clean-up of site, scaffolding, and access equipment.



—

Why Multi-Storey Properties Require Specialists

Unlike single-storey spraying, multi-level jobs demand:

Safety planning – Harnesses, tie-offs, or scaffold depending on site.

Insurance compliance – Only licensed, insured contractors can legally spray at height.

Experience – Masking and spraying at heights requires steadiness and planning.

Team efficiency – Multiple painters often required to complete jobs quickly.


This is not work that can be rushed — or done by painters without aluminium expertise.


—

Popular Colours for Multi-Storey Properties

Colour choices remain consistent across single and multi-storey homes, but upper levels amplify their impact:

Black – Sleek, disappears into glass, striking at height.

White – Bright, crisp, perfect with shutters or cladding.

Monument – Dark grey, modern and versatile.

Surfmist – Coastal grey-white for softness.

Ironstone – Neutral depth, balances stone and timber.


These colours complete the exterior, making townhouses and multi-storey homes look cohesive and modern.


—

Why Spraying Beats Replacement

For multi-storey properties, replacement is even more disruptive than repainting:

Demolition mess across two or three floors.

Render and plaster damage inside and out.

Cost blowouts for scaffolding and new units.

Landfill waste from old frames and glass.


Spraying avoids all of this by modernising frames onsite — quickly, safely, and sustainably.


—

Gold Coast Suburbs Where Multi-Storey Spraying Matters Most

Southern suburbs – Currumbin, Palm Beach, Elanora, Burleigh Heads, Tugun.

Central suburbs – Broadbeach, Mermaid Waters, Southport, Chevron Island, Isle of Capri.

Hinterland – Mudgeeraba, Worongary, Bonogin, Tallai.

Northern suburbs – Robina, Upper Coomera, Helensvale, Ormeau, Pacific Pines.


From beachfront homes to elevated acreage, multi-storey properties are everywhere on the Gold Coast — and all benefit from professional aluminium window spraying.


—

Benefits of Multi-Storey Aluminium Window Spraying

Factory-quality results – HVLP spraying delivers flawless finishes.

Durability – Built for UV, salt, and humidity.

Safety compliance – Jobs done legally and insured.

Street appeal – Modern, cohesive look for the entire façade.

Eco-friendly – Extends lifespan of existing aluminium, avoids landfill.



—

FAQs – Multi-Storey Aluminium Window Spraying

Q: Do you need scaffolding for two-storey jobs?
Sometimes — we assess each site and use scaffolds, ladders, or lifts depending on access.

Q: Can spraying be done on occupied townhouses?
Yes — we work onsite without removing frames, minimising disruption.

Q: How do you protect upper-level glass?
With full masking sheets, professional tapes, and tested systems that hold even in wind.

Q: Is spraying faster than replacement in multi-storey properties?
Much faster — and far less disruptive.

Q: Will the coatings last at height?
Yes — with primers and multiple coats, finishes perform even under harsher UV and salt exposure.


—

Why Choose RepaintPro

Multi-storey specialists – Decades of experience across Gold Coast townhouses and double-storey homes.

Licensed and insured – Fully compliant with QBCC and safety regulations.

Technical expertise – Correct film builds and adhesion systems.

Factory finishes – Every frame sprayed to perfection.



—

The Bottom Line

If you own a two-storey home, townhouse, or multi-level property, don’t let outdated aluminium frames ruin the look. With professional aluminium window spraying, you can modernise instantly — without replacement, demolition, or landfill waste.

From Burleigh to Southport, Robina to Ormeau, RepaintPro delivers safe, durable, and factory-quality results for multi-storey aluminium window spraying Gold Coast–wide.

???? Call Steve today on 0403 311 125 to discuss your multi-storey project and get a finish that lasts.